[Nfb-krafters-korner] loom clips

[Brandy Wojcik]

Yes the one I'm trying to put it on has a rounded end. I just got the new
clips today and I'll give it a try when the little ones are gone.

-----Original Message-----
From: nfb-krafters-korner-bounces at nfbnet.org
[mailto:nfb-krafters-korner-bounces at nfbnet.org] On Behalf Of Powers, Terry
(NIH/OD/DEAS) [E]
Sent: Monday, October 01, 2012 7:45 AM
To: 'List for blind crafters and artists'
Subject: Re: [Nfb-krafters-korner] loom clips

Brandy,
The looms that work with the clips, have a rounded corner, not these that
are out with a square end.

Terry P.
 

-----Original Message-----
From: Cathy [mailto:flowersandherbs at gmail.com] 
Sent: Thursday, September 27, 2012 6:31 PM
To: 'List for blind crafters and artists'
Subject: [Nfb-krafters-korner] loom clips

Hi Bran,

Can't remember, but do you have the Provo Craft knifty knitter brand long
loom specifically? If not, this might be why the clips do not work. my KK
long looms have a hole on the bottom side near every peg. I set the "rails"
of the loom into the indentations on the loom clip, center the hole on each
side over the little pegs coming up from the clips, and press down on the
loom. it takes a bit of wiggling and strength, but the pegs should pop into
the holes and lock into place.

Cathy



_______________________________________________
Nfb-krafters-korner mailing list
Nfb-krafters-korner at nfbnet.org
http://nfbnet.org/mailman/listinfo/nfb-krafters-korner_nfbnet.org
To unsubscribe, change your list options or get your account info for
Nfb-krafters-korner:
http://nfbnet.org/mailman/options/nfb-krafters-korner_nfbnet.org/terry.power
s%40nih.gov

_______________________________________________
Nfb-krafters-korner mailing list
Nfb-krafters-korner at nfbnet.org
http://nfbnet.org/mailman/listinfo/nfb-krafters-korner_nfbnet.org
To unsubscribe, change your list options or get your account info for
Nfb-krafters-korner:
http://nfbnet.org/mailman/options/nfb-krafters-korner_nfbnet.org/ballstobook
s%40gmail.com