[Nfb-krafters-korner] Help with plastic canvas

[Powers, Terry (NIH/NCI) [E]]

Hi bobby;
You are always working across the bottom of the square, in this project.  
2/1 to 3/2
1/1 to 3/3
1/2 to 3/4
Continue across in an up 2 bars over 2 bars until you have 2 empty squares.
Turn project 90 dgs and repeat.
First 3 stitches will inter lock with your first section.

Terry P.


-----Original Message-----
From: Bobbi Lofton via Nfb-krafters-korner [mailto:nfb-krafters-korner at nfbnet.org] 
Sent: Saturday, May 16, 2015 8:14 PM
To: Nfb Krafters Korner
Cc: Bobbi Lofton
Subject: [Nfb-krafters-korner] Help with plastic canvas

Now I finally got this email sending from the correct account. This message is for Terry Powers.
Terry, my mother went to Walmart today to do some things and purchased for me the 4 inch canvas squares like you mentioned. I tried to start the coasters today, but I'm not sure which way to go after I go from 1-1 to 3-3. I've looked at the picture, but I cannot figure out from the picture which way to go. I'm not sure if I'm holding the picture the right way.

Bobbi Lofton

Sent from my iPad
_______________________________________________
Nfb-krafters-korner mailing list
Nfb-krafters-korner at nfbnet.org
http://nfbnet.org/mailman/listinfo/nfb-krafters-korner_nfbnet.org
Division Website:  http://www.krafterskorner.org Facebook page:  https://www.facebook.com/pages/NFB-Krafters-Division/269246643109571
"Follow NFB Krafters Korner on Twitter: Our Handle is @craftingblind Don't have a Twitter account? You can still follow Krafters Korner on Twitter. Go to: Twitter.com/craftingblind To unsubscribe, change your list options or get your account info for Nfb-krafters-korner:
http://nfbnet.org/mailman/options/nfb-krafters-korner_nfbnet.org/terry.powers%40nih.gov