[NFBCS] Question regarding stuck key issue on Focus 40
Nathaniel Schmidt
schmidty2244 at gmail.com
Mon Nov 30 06:47:49 UTC 2020
Hmmm. Interesting. I wonder if the grouped eight-cell ribbon idea for the
hardware is perhaps not always working quite as well as it should. Or maybe
there is something else going on in your case.
Nathaniel
> -----Original Message-----
> From: NFBCS <nfbcs-bounces at nfbnet.org> On Behalf Of Sahar's Beaded
> Creations via NFBCS
> Sent: Monday, 30 November 2020 2:38 PM
> To: 'NFB in Computer Science Mailing List' <nfbcs at nfbnet.org>
> Cc: Sahar's Beaded Creations <saharhusseini at gmail.com>
> Subject: Re: [NFBCS] Question regarding stuck key issue on Focus 40
>
> I wonder if the New Focus model has issues. I needed to get a couple of
> units replaced. I just sent mine in for repair, and it still isn't right.
> Some dots stay up longer than they should, and some cells don't raise like
> the others. It's very disappointing.
>
> Warm regards,
> Sahar Husseini
> For hand-crafted, one-of-a-kind jewelry, please visit my Website at
> www.saharscreations.com Find me on Facebook at
> www.facebook.com/saharscreations And remember, "Obstacles don't have
> to stop
> you. If you run into a wall, don't turn around and give up.
> Figure out how to climb it, go through it, or work around it."
> Michael Jordan
>
> -----Original Message-----
> From: NFBCS <nfbcs-bounces at nfbnet.org> On Behalf Of Nathaniel Schmidt
> via
> NFBCS
> Sent: Sunday, November 29, 2020 8:11 PM
> To: 'NFB in Computer Science Mailing List' <nfbcs at nfbnet.org>
> Cc: Nathaniel Schmidt <schmidty2244 at gmail.com>
> Subject: Re: [NFBCS] Question regarding stuck key issue on Focus 40
>
> Hi,
>
>
>
> Your problem sounds very similar to one I discovered when I got my
> completely new 5th gen Focus 40 Blue display several months ago. One
> entire
> cell would not react to input and output queries and I had to immediately
> send it away for repairs. No one could figure out how or why it was
> happening, because the cells are connected in groups of eight on the 40
cell
> model, so theoretically issues like this should impact upon more than one
> cell.
>
>
>
> The diagnostics
> <https://support.freedomscientific.com/Content/Documents/Manuals/Focu
> s/Focus
> -Blue-Online-Users-Guide.htm#diagnosticsmode> section of the 5th Gen
> manual
> contains instructions on how to clean the display , if you think this may
> solve your problem:
>
> Display Test/Clean
>
>
>
> It is necessary to disconnect the Focus Blue from your computer and make
> sure it is powered off before beginning this test. The display test is
used
> to ensure that each pin on the braille display can be activated. The
display
> test also allows you to clean the braille display. Press the Power button
> while pressing the rightmost Cursor Router buttons (above the last two
> cells) simultaneously. This action causes all cells to be activated for
> cleaning. Use a soft cloth moistened with isopropyl alcohol. Do not use
any
> other substance to clean the cells.
>
> While in this mode, pressing down on either the Right or Left NAV Rocker
> will cause all of the cells to be deactivated. Pressing up on either the
> Left or Right NAV Rocker will reactivate all cells.
>
> Pressing the Left or Right NAV Mode button causes the cells to toggle up
and
> down. To stop this action, press the NAV Mode button again.
>
>
>
> Hope this helps.
>
>
>
> Regards,
>
>
>
> Nathaniel
>
>
>
> ========================================
>
> Nathaniel Schmidt
>
> Undergraduate student
>
> Bachelor of Computer Science (S306)
>
> School of Information Technology
>
> Faculty of Science, Engineering and Built Environment
>
> Deakin University, Melbourne (Burwood) campus
>
> https://sync.deakin.edu.au/profiles/student/njschmidt/
>
>
>
> Std. ID: 220493627
>
> E: njschmidt at deakin.edu.au <mailto:njschmidt at deakin.edu.au>
>
> M: 0439591709
>
> LinkedIn: https://www.linkedin.com/in/njsch/
>
> GitHub: https://github.com/njsch/
>
> Skype: nathaniel_schmidt1994
>
> about.me/njschmidt/ <https://about.me/njschmidt/>
>
>
>
> From: NFBCS <nfbcs-bounces at nfbnet.org> On Behalf Of Purvi Contractor via
> NFBCS
> Sent: Monday, 30 November 2020 6:47 AM
> To: nfbcs at nfbnet.org
> Cc: Purvi Contractor <purvidc2 at gmail.com>
> Subject: [NFBCS] Question regarding stuck key issue on Focus 40
>
>
>
> Hi,
>
>
>
> I hope everyone had a great Thanksgiving.
>
> Recently, I noticed that the one of the dot keys on my Focus 40 Blue
Braille
> Display remains stuck in the pressed position and requires manual effort
to
> release it.
>
> Can anyone please provide suggestions on how to fix this issue? Can the
key
> be easily taken out for cleaning ?
>
>
>
> Thank s for your help.
>
> Regards,
>
> Purvi
>
>
>
> _______________________________________________
> NFBCS mailing list
> NFBCS at nfbnet.org
> http://nfbnet.org/mailman/listinfo/nfbcs_nfbnet.org
> To unsubscribe, change your list options or get your account info for
NFBCS:
> http://nfbnet.org/mailman/options/nfbcs_nfbnet.org/saharhusseini%40gm
> ail.com
>
>
> _______________________________________________
> NFBCS mailing list
> NFBCS at nfbnet.org
> http://nfbnet.org/mailman/listinfo/nfbcs_nfbnet.org
> To unsubscribe, change your list options or get your account info for
NFBCS:
> http://nfbnet.org/mailman/options/nfbcs_nfbnet.org/schmidty2244%40gm
> ail.com
More information about the NFBCS
mailing list